CLiC-iT PROTECTMAN RODEOSTOP B100 Benutzerhandbuch Seite 14

Bottom view internal view side view
Make sure that the rope (3) has passed all-round the center of the pulley (4) until it
comes out on the other side in the U groove (13) between the two braces (11) at the
bottom of the apparatus.
Check again that the safety rope (3) is correctly installed in the apparatus by gently
pulling it in both directions. The rope should circulate freely on the pulley. Then give
the rope a sharp pull. This should stop the rope and block it. Do the same with the
other side. This should produce the same results by stopping and blocking the rope.
VIII. CHARACTERISTICS OF PERSONAL SAFETY
Equipment that require checking before use.
Carefully read everything, but particularly sections VII, XV and XVI of the instructions
for Use of the RODEOSTOP B100 before use, then take time to check all the
equipment.
Harness: check the straps, the stitching of the seams, the state of the buckles and
the signs of corrosion and warping. Also, the general cleanliness and freedom from
dirt.
Sling: check the condition steel or strap, signs of cracking, the good state of the
markings and traces of knocks.
Check that all fixtures are tight and in good condition.
Hold up the apparatus and check that the full length of the rope is in good working
order with no traces of burning, oil, wear and tear, cuts and no sign of parasitic
knots.
- 4 -