Program Selection - Stageline DMX-192PLAY Bedienungsanleitung

4 Program Selection

The scenes loaded can be selected with different circuits. The circuit to be used has to
be configured in the setup menu or the DMX configurator (see chapter Configuration).
The last scene selected is memorized and automatically started after switching
on again.
Also see "Default Scene on Start"
The scenes and chases memorized can be selected with the buttons Chase- and
Chase+ on the DMX-192PLAY. The chase selected in each case is shown on the
3-digit LED display. To activate the chase, press the Start button. An LED point on the
right at the bottom serves as a check.
To communicate via the USB interface with the computer (to transfer chases
and scenes and for live operation), stop the program in the DMX-192PLAY.
For this purpose, press the Start button for at least 2 seconds until the LED
point disappears on the right at the bottom of the display. Also for operation
with the IR remote control stop the program for the time being.
5 Speed
Adjust the speed with the potentiometer Speed. The time between the steps of a chase
can be varied from approx. 1/6 seconds to 40 seconds. If a fade time between the steps
has been programmed, this time is proportionately considered in the total speed and
also changed with the control.
DMX-192PLAY
11