Important Safety Instructions; Unpacking - Computar Cs4.1 Bedienungsanleitung

W celu zmiany czasu kamery w sekwencji
nale˝y odpowiednio ustawiç tarcz´
umieszczonà z ty∏u jednostki.
4
3
2
1
SKIP
CS8.1
Aby zmieniç ustawienie
Aby wybraç kamer´
sekwencji naciÊnij i
naciÊnij przycisk wyboru
przytrzymaj przycisk 'SKIP'
kamery
a nast´pnie naciÊnij
przyciski wyboru kamer
Zwolnij przycisk 'Skip' aby powróciç do normalnej pracy.
Prosz´ pami´taç ˝e sekwencja musi sk∏adaç si´ z minimum dwóch kamer aby dzia∏a∏a
prawid∏owo. Je˝eli spróbujesz w∏àczyç sekwencj´ sk∏adajàcà si´ z mniej ni˝ dwóch kamer
wówczas automatycznie zostanà w∏àczone do sekwencji kamery 1 do 4.
5
6
7
8
AUTO
computar
Aby rozpoczàç
sekwencj´ naciÊnij
przycisk 'AUTO'
22
Installation Instructions for CS4.1 & CS8.1 Video Switcher

1) IMPORTANT SAFETY INSTRUCTIONS

Before commencing with the installation of this equipment read these instructions carefully
and act on the information herein.
Never attempt to gain access to the equipment without first disconnecting the mains supply
to the unit.
Consideration should be given as to the correct installation of the unit. The equipment has
been designed for indoor use only and must not be installed in any situation where air flow
around the unit is restricted, where there are strong heat sources (such as intense direct
sunlight, radiators etc.) or in areas of extreme cold.
Before siting the unit, ensure that the user can operate the equipment comfortably without
causing repetitive strain. Each unit has been designed to minimise the amount of user
fatigue that may be caused during normal operation.
Never operate the equipment with damp or wet hands.
Do not push any objects into openings.
Do not use the equipment whilst drinking or allow the equipment to be used near to areas
which may get wet. Spillages invariably cause damage to the unit and may result in personal
injury.
Only use the power supply unit that was supplied with your switcher. Do not use this power
supply for any other purpose. Failure to comply may result in damage or serious injury.

2) Unpacking

Carefully unpack your Video Switcher. Your package should contain the following items:-
Video Switcher (CS4.1 or CS8.1)
12vDC Power Supply Unit
These Instructions
Retain the packing material. If any item is missing or damaged DO NOT ATTEMPT TO USE
THIS EQUIPMENT. Contact your supplier immediately.
3