Royal Catering RCSA-S228 Benutzerhandbuch Seite 7

BUTTON COMBINATIONS
Lock/unlock buttons
Initiate service programming
mode – ATTENTION! IT IS
RECOMMENDED NOT TO
INITIATE THE SERVICE MODE –
all the factory parameters were
set in this mode and changes
may result in incorrect device
operation.
Return to ambient temperature
display.
SYMBOL MODE DESCRIPTION
ON Compressor is active
Flashing Prevention of short operation
periods activated
ON Active defrosting
Flashing Active dripping
ON Fan ON
Flashing Delayed ventilator activation
after defrosting
ON Unit of temperature
Flashing Programming mode
ON Unit of temperature
Flashing Programming mode
DISPLAYING SETTINGS:
1. Briey press the SET button and the current setting
will be displayed.
2. To return to the standard screen briey press SET or
wait for approximately 5 seconds.
CHANGING SETTINGS:
1. Press and hold down the SET
approximately 3 seconds
2. The current setting will be displayed and °C or °F
diode will ash.
3. Change the setting using or
4. To accept changes press the SET button.
LOCKING BUTTONS:
Press and hold down the and
least 3 seconds. „OF" will be displayed – the buttons are
now locked.
UNLOCKING BUTTONS:
Press and hold down the and
least 3 seconds. „on" will be displayed – the buttons are
now active.
1 2
Assembly/disassembly of the device's elements:
Assembly of a 2 drawer set:
Attach upper drawer posts (1),
attach cross bars (2) to drawer
posts to the 4th opening from
the top:
1
2 2
1
1
1
Screw in the cross bar
separating the drawers:
Assembly of a 3 drawer set:
Attach upper drawer posts (1),
attach cross bars (2) to drawer
posts to the 2nd opening from
the top:
1
2
1
1
1
Attach bottom cross bars to
the last hole from the top:
1
2
1
2
1
button for
Insert the top and bottom
drawers:
.
buttons for at
buttons for at
ASSEMBLY OF THE GLASS TOP (applies to model
RCSA-S228 only):
• remove glass top from packaging,
Attach lower cross bars
(2) to the 11th opening
from the top:
1
1
2
1
2
1
First insert the top drawer,
then the bottom drawer:
Attach middle posts to
the 7th opening in the
post from the top:
1
2
1
1
2
1
Attach both cross bar
separating the drawers:
1
The deeper drawer goes
on the bottom:
R e v . 1 1 . 0 1 . 2 0 1 8