Product Usage - Romoss Rx1000 Benutzerhandbuch

Product Usage

•
Turning On: To turn on the product, press and hold the main power switch. This action
simultaneously lights up the LCD screen. If the product is in sleep mode, a single press of
the main power switch will activate the LCD screen.
•
Turning Off: To turn off the product, press and hold the main power switch. Note that
the product will remain on if a charging input source is connected.
•
Using USB Output: Ensure the main power supply is on. Press the DC button to activate
the blue lamp. Once the lamp is on, the USB output ports (USB-A and USB-C) are
available for use. To deactivate, press the DC button again, which will also turn off the
blue lamp.
•
Using 12V DC Output: Confirm that the main power supply is on, and press the DC
button to activate the blue lamp. This enables the 12 V DC output port, such as a cigar
lighter (DC5525). To turn off, press the DC button again, which deactivates the output and
the lamp.
•
Using AC Output: With the main power supply turned on, press the AC button to
activate the blue lamp. The AC output port can then be used. For additional functionality,
hold the AC button to switch to parallel output mode (indicated by the orange lamp).
Hold the AC button again to deactivate the output.
•
Using the Lamp: Press the lighting button to turn on the flashlight. Pressing the button
again switches to the LED lamp. Pressing it a third time turns off all lights. Holding the
lighting button activates SOS mode for the flashlight. Press and hold to exit SOS mode.
•
Parallel and Constant Power Modes: Upon startup, the product defaults to Constant
Power mode. To switch to Parallel mode, turn off the device, then press and hold the AC
button for three seconds. This allows the connection of two or more power supplies in
parallel. To revert to Constant Power mode, press and hold the AC button again for three
seconds. In Constant Power mode, the LCD displays "AC(R-MAX)" when enabled. In
Parallel mode, it displays "AC(R-RISE)."
Note:
Using the parallel function requires purchasing a separate parallel connection box.
If the product has been stored for a long time, it may enter sleep mode. Fully charging the
product for at least 10 minutes with an adapter will activate it. It is recommended to fully
charge the product before first use to prevent any inconvenience caused by insufficient
battery levels.
10