WorkPro RP17313 Originalbetriebsanleitung Seite 8

9. Trouble shooting
The following form lists the common operating system with problem and solutions. Please read the form carefully
and follow it.
Warning!
If any of the following symptoms appears during your operating, stop using the tool immediately, or serious
personal injury could result. Only a qualified persons or an authorized service center can perform repairs or
replacement of tool.
PROBLEM
Tool runs at
normal speed but
loses under load
Tool runs slowly.
Air flows slightly
from exhaust
Tools will not run.
Air flows freely
from exhaust
Tool will not shut
off
POSSIBLE CAUSES
 Motor parts worn.
Cam clutch worn or sticking due to

lack of lubricant.
 Motor parts jammed with dirt
particles.
Power regulator in closed position

Air flow blocked by dirt.

One or more motor vanes stuck due to
material build up."O" rings throttle
valve dislodged from seat inlet valve.
"O" rings throttle valve dislodged from
seat inlet valve.
NOTE: Repairs should be carried out by a qualified person.
GB
Lubricating clutch housing.
 Check for excess clutch oil. Clutch
cases need only be half full. Overfilling
can cause drag on high speed clutch
parts, ie. a typical oiled/lubricated
wrench requires 1⁄2 ounce of oil.
GREASE LUBRICATED.

NOTE: Heat usually indicates insufficient
grease in chamber. Severe operating
conditions may require more frequent
lubrication.
Check air inlet filter for blockage.
 Pour air tool lubricating oil into air inlet
as per instructions.
Operate tool in short bursts quickly

reversing rotation back and forth where
applicable.
Repeat above as needed.

Pour air tool lubricating tool into air
inlet.
Operate tool in short bursts of forward

and/or reverse rotation where applica-
ble.
Tap motor housing gently with plastic

mallet.
Disconnect supply. Free motor by

rotating drive shank manually where
applicable
Replace "O" ring.
8
SOLUTIONS