Practical Tips; Disposal And Recycling; Cleaning And Maintenance - Workpro Rp17313 Originalbetriebsanleitung

6. Operation
6.1 Connecting to a compressed air supply
Connect the air connection (6) to the quick-lock

coupling of a compressed air hose (the hose is not
supplied).
Note the maximum permissible operating pressure

of the equipment.
6.2 Switching on and off (Fig. 1)
With a firm grip on the straight die grinder, slowly apply
hand pressure to the operating switch until the desired
speed is obtained, and steadily moving tool to right
and left until achieving desired appearance (finish) on
workpiece.
NOTE: The tool always turns the Grinding Drum/Drill
Chuck clockwise.
If air straight die grinder requires more force to accomplish

task, verify that it receives sufficient, unobstructed
airflow (CFM) and increase pressure (PSI) output of
regulator up to maximum air pressure rating of tool.
If the tool still does not have sufficient force at

maximum pressure and sufficient airflow, then a
larger tool may be required.
 Turn off air compressor. Slowly squeeze the
operating switch to release any remaining air
pressure from Die Grinder. Then disconnect air
hose.

6.3 Practical tips

Exert only moderate pressure on the workpiece, so

that it can be machined at constant speed.
Instead of accelerating your work, high pressure will

cause the drive unit to slow down and even stop.
For your own safety, it is essential to secure small

workpieces with a screw clamp or vise.
 Precision work/engraving: Hold the drive unit like a
pen (single-handed).
Rough work: Hold the drive unit like the handle of a

hammer (two-handed).

7. Cleaning and maintenance

Disconnect the compressed air supply from the
equipment before performing any cleaning work.
7.1 Cleaning
 Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible. Wipe
the equipment with a clean cloth or blow it with
compressed air at low pressure.
We recommend that you clean the device immedi-

ately each time you have finished using it.
GB
Clean the equipment regularly with a moist cloth

and some soft soap. Do not use cleaning agents or
solvents; these could attack the plastic parts of the
equipment. Ensure that no water can seep into the
device.
7.2 Maintenance
Warning!
Disconnect the equipment from the compressed air
supply before you carry out any maintenance or
cleaning work.
Compliance with the maintenance instructions listed
here will help this quality product provide you with a
long service life and trouble-free operation.
Regular lubrication is essential for your equipment to
work properly for a prolonged period of time.
Regularly check the speed and the vibration level by
simply observing the tool.
NOTE: Use environmentally friendly compressed air oil
if you want to operate the equipment outside the
workshop.
The following lubrication options are available:
Lubrication
Each time before using the compressed air tool insert
3-5 drops of special compressed air oil into the
compressed air connection. If the compressed air tool
has not been used for several days you must insert
5-10 drops of special compressed air oil into the
compressed air connection before switching on.
Store your compressed air tool only in a dry room.

8. Disposal and recycling

If your tool has become damaged beyond repair, do
not throw it out. Bring it to the appropriate recycling
facility.
7