Important Safety Notes; Assembly/Set-Up; Scope Of Delivery - Jupiter Retro Bedienungsanleitung

Operating Instructions Retro Manual Slicer
Congratulations on the purchase of your
EN
new JUPITER kitchen appliance. You have
chosen a high-quality, modern appliance. Further
information on this and other products is
available on our website at
This appliance is intended for slicing bread, sausage,
cheese etc. in normal domestic quantities in a do-
mestic environment or in domestic-like non-com-
mercial applications.
Domestic-like applications include, for example,
use in staff break rooms in shops, offices, agricultural
and other commercial businesses, small hotels and
similar residential facilities. Only use the appliance
for normal domestic processing quantities and peri-
ods of time. The appliance is maintenance-free.
Please read the operating instructions and, in
particular, the safety notes, before using the
appliance for the first time.
IMPORTANT:
Keep the operating instructions safe
and always store them with the appliance.

Important safety notes

The blade of the slicer is very sharp!
Handle it with care.
Sharp parts can cause injury!
CAUTION
• Children should not use the appliance. They should
not play with it either.
• This appliance may be used by persons with
physical, sensory or mental disabilities, or by those
who lack experience and/or knowledge, if they are
supervised or have been instructed in the safe use
of the appliance and have understood the dangers
involved.
• The appliance may only be repaired by
customer service.

Scope of delivery

• Slicer
• Crank handle
• Suction feet (x4)
• Table clamp (table thickness approx. 2 - 6 cm)
• Operating instructions
4 Subject to technical changes without notice; no responsibility is accepted for the accuracy of this information.
www.my-jupiter.de
JUPITER
Components of the slicer
A Thickness guide
B Crank handle
C Suction feet
D Base plate
E Adjusting knob for slice thickness (0 - 20 mm)
F Blade (rust-proof)
G Blade locking screw
H Borehole for table clamp
A
H E D
F
G

Assembly/Set-up

Sharp parts can cause injury!
CAUTION
The blade of the slicer is very sharp!
Handle it with care.
• Screw the 4 suction feet C
base plate D and press the slicer onto the table.
• If required, push the table clamp into the bore-
hole H of the base plate and use it to secure the
manual slicer to the table top/worktop (thickness
approx. 2 - 6 cm).
• Screw the crank handle
handle thread until the blade turns.
B
C
into the thread of the
B clockwise onto the crank