Maintenance - Summit Easyfloat Uv Installations- Und Benutzerhandbuch

Manual for: SUMMIT EasyFloat UV 40W / 80W / 130W
EN

4. Maintenance

The correct functioning of the SUMMIT EasyFloat system is only guaranteed if original spare parts and components are
used as described in this manual. The parts described must also be inspected, replaced or cleaned in a timely manner. If
instructions are not followed, there is a risk of malfunction or damage to the UV system. If non-original spare parts and
components are used or if the inspection, replacement or cleaning is not carried out in time, the warranty on the entire
UV system will lapse.
The safety instructions in this manual must be followed at all times, but they do not
affect the local and/or legally applicable safety measures and instructions.
UV-C radiation can damage the retina of your eyes and unprotected skin. Ensure
that you are not directly or indirectly exposed to UV radiation. Everyone involved
must be informed about the specific hazards associated with a UV system.
Grasp all quartz glass parts only with clean gloves on, which do not leave any
residues or prints. If fingerprints or dirt are present on the quartz parts, the UV-C
radiation is negatively influenced, so that the UV-C treatment process is also
negatively affected. Quartz can cause serious harm you skin by cutting in the
event of breakage.
General steps of maintenance:
1. Switch off the UV system;
2. Clean Quartz Glass with an acidic solution (i.e. citric acid)
3. If lamp life is expired replace the lamp
W W W . S U M M I T WA T E R S Y S T E M S . N L
17