BGS technic 3224 Bedienungsanleitung Seite 6

5. Putting into operation
5.1. Air supply and connections. Only use filtered, lubricated, and regulated compressed air. The
following illustration shows the correct mode of connection to the air supply system which will
increase the efficiency and useful life of the tool.
5.2. Before starting Before connecting the air hose, apply 4 to 5 drops of SAE#10-20 spindle oil at the
air inlet. Also, every 3 to 4 hours of operation, oiling is necessary. Twist Teflon thread tape to
ensure a proper seal air inlet. Then tighten the air coupler into air high speed grinder.
5.3. Only lubricants recommended by the manufacturer shall be used.
5.4. Disconnect air supply from air inlet.
5.5. Insert the attached sockets ,adaptor or extension bar. Always use impact wrench sockets and
accessories in good condition and are intended for use with power tools.
5.6. Release the trigger in the case of an interruption of the energy supply.
5.7. This air impact wrench is designed for Right/Left rotating direction. Forward and reverse direction is
controlled by pushing the button noted. "F" (forward) right direction (clockwise), for tighten regular
screw. "R"(reverse) left direction (counterclockwise), for loosens regular screw.
6. Maintenance instruction
Air tools require lubrication throughout the life of the tool. The air motor and bearing uses compressed
air to power the tool. Because moisture in compressed air will rust the air motor, you must lubricate
the motor daily.
6.1 Lubrication
6.1.1. Disconnect the tool from the air supply holding it so the air inlet faces up.
6.1.2. Hold the trigger down and put 4 to 5 drops of air tool oil or motor oil SAE1 0-20 in the air inlet.
Holding the trigger down helps circulate oil in the motor.
6.1.3. Connect the tool to air supply, cover the exhaust port with a towel and run for a few seconds.
Warning! Any excess oil in the motor is immediately expelled from the exhaust port. Always direct
exhaust port away from people or objects.
6.2. Before connecting the air hose, apply 4 to 5 drops of air tool oil SAE10-20 spindle oil at the air
inlet. Also, every 3 to 4 hours of operation, oiling is necessary.
6.3. Storage Avoid storing the tool in a location subject to high humidity. If the tool is left as it is used,
the residual moisture inside the tool can cause rust. Before storing and after operation, oil the tool
and run it for a short time.
6.4. Regular inspection of spindles, threads, and clamping devices in respect of wear and tolerances
for location of abrasive products.
6.5. Disposal If the tool is too seriously damaged to be used anymore. Recycle raw material instead of
disposing as waste. The machine, accessories and packaging should be sorted for environmental-
friendly recycling. Check with your local authority or retailer for recycling advice. Defective or worn
out power tool must be recycled according to the Directive WEEE 2002/96/EEC.
SW-Stahl und Werkzeugvertriebs GmbH
L e v e k r u s r e t S a r s s e 6 5
D 4 - 2 8 9 7 R e m s c h e d i
Tel. +49 (0) 2191 / 46438-0
F ax +49 (0) 2191 / 46438-40
- E M a : l i n i o f @ s w s a t l h d . e