Initial Operation - Vlahova Rb3568 Bedienungsanleitung

A3: Channel number
A5: Remote sensor low battery indicate
B1: °C /°F unit transfer button
B3: Channel switch
C1: Transmit indicating lamp
C3: Wall mounting hole
C5: Battery compartment

Initial operation

 Open the main unit battery compartment cover.
 Insert 2PCS size AAA batteries observing polarity【 "+" and " –" marks】.
 When you insert the batteries, all the icon on the LCD display will briefly light up for 3 seconds, and you will
hear a beep tone, then detect ambient temperature/ relative humidity.
 The Weather Station will try to make a connection to the outdoor remote sensor. This process lasts for a
maximum of 3 minutes and will displayed by a flashing reception antenna symbol
display area on the receiver.
 This now, Open the remote Sensor battery compartment cover, push the channel switch to the "1" position,
Insert 2 x AA batteries observing polarity ("+" and "–" marks), close the battery cover.
 If there are multiple remote controls, according to the same method, push the channel switch to the "2" or
"3" position, establish another 2 remote sensor connections.
 After about 3 minutes, it will enter the Radio control receive mode.
Reception of the Radio signal
 When entering DCF signal receiving mode，the icon
symbol will not flash, and the symbol
 At 1:00 / 2:00 / 3:00, the clock automatically carries out the synchronization procedure with the DCF signal
to correct any deviations to the exact time. If this synchronization attempt is unsuccessful (the icon
disappears from the display), the system will automatically attempt another synchronization at the next full
one hour. This procedure is repeated automatically up to total 5 times.
 To start manual DCF signal reception, press and hold the "-" button for 2 seconds. If no signals received
within 7 minutes, then the DCF signal search will stop.
 During RC reception，to stop searching radio signal, press the "-" button once.
：Received successfully
： The previous reception was successful, but the last reception failed
：RCC function is set to OFF
F.Y.I.:
 RCC = Radio Controlled Clock.
 We recommend the product be placed at a minimum distance of 2.5 meters (8.2Feet) to all sources of
interference, such as televisions or computer monitors or switching power adapter.
RB3568
A4: Remote sensor humidity
B2: Manual transmitter button
C2: Battery compartment cover
C4: Stand cover
starts to flash. When a valid signal is identified, the
will flash.
in the remote sensor