Initial Operation; Manual Time Setting - Vlahova Rb3552 Handbuch

Initial operation

 Open the main unit battery compartment cover
 Insert 2 x AAA batteries with correct polarity【"+" and " –" marks】
 When you insert the batteries, the all icon on the LCD will light up for 3 seconds, and you will hear a beep tone, then
detect indoor temperature.
 The main unit will now start to make a connection to the outdoor remote sensor. This operation takes about 3 minutes
and will display by a flashing reception RF antenna symbol in the "OUTDOOR" display area on the receiver.
 This now, Open the remote Sensor battery compartment cover, Insert 2 x AAA batteries with correct polarity 【"+"
and "–" marks】
 After receiver has created a connection to the outdoor remote sensor, it will enter the Radio control time receive
mode.
Reception of the Radio signal
 The clock automatically starts the DCF signal search of any restart or changing of new fresh batteries. The radio mast
icon starts to flash.
 At 1:00 /2:00 / 3:00 am, the clock automatically carries out the synchronization procedure with the DCF signal to
correct any deviations to the exact time. If this synchronization attempt is unsuccessful (the radio mast icon
disappears from the display), the system will automatically attempt another synchronization at the next full one hour.
This procedure is repeated automatically up to total 5 times.
 To start manual DCF signal reception, press and hold the 【
minutes, then the DCF signal search stops (the radio mast icon disappears) and start again at the next full one hour.
 During RC reception, to stop searching radio signal, press the 【
F.Y.I.:
 A flashing radio mast icon indicates that the DCF signal reception has started
 A continuously displayed radio mast icon indicates that the DCF signal was received successfully
 We recommend a minimum distance of 2.5 meters to all sources of interference, such as televisions or computer
monitors
 Radio reception is weaker in rooms with concrete walls (e.g.: in cellars) and in offices. In such extreme circumstances,
place the system close to the window.
 During the RC receive mode, only the 【
If you want to carry out other functions of operation, please press 【

Manual time setting

 Press and hold the button
buttons to adjustment the value, Press button
sequence of setting items is as follows:
➔
RCC ON/OFF TIME format(12/24HR)
➔ ➔
YEAR MONTH
 Press button to confirm the last item to end the setting procedures, then it will return to the normal mode.
Weekly language settings are shown in the table below:

for 2 seconds, into the setting mode, the set item will blink display. Press "+" or "-"
➔
ZONE(-12~12)
➔ ➔
DATE Language of week
-
】button for 2 seconds. If no signals received within 7
-
】 button once.
-
】 and 【 】button function, other button operation have no function,
-
】 button to exit the RC receiving mode.
to confirm the item has been set and go to the next one, the
➔
HOUR
➔ ➔
MINUTE DATE format(D/M or M/D)