Konig SAS-TRANS61 Anleitung Seite 12

ENGLISH
Alarm
When PIR detection is set to on, the system will give an alarm when motion is detected.
1. Select alarm in the main menu and press OK.
2. The screen shows PIR detection, press OK.
3. Press "On" or "Off" with the up and down arrow button.
4. Press OK to confirm and exit.
Live view:
Press the quarter display button to select the type of view.
Time stamp
Picture in picture view
Quad view Full screen view
Note: use the left and right arrow button to select a camera.
Press the display mode button to enter cyclic mode view. Five cyclic intervals are available:
5s, 10s, 15s, 20s, and 30s and can be set under System > Scan Mode Period in the main menu.
12