Yamaha SRT-700 Bedienungsanleitung Seite 19

Bluetooth
Problem Cause
Cannot make the is not selected as the
input source.
unit pair with the
Bluetooth
The device does not support
device.
A2DP.
A adaptor, etc., that you
want to pair with the unit has a
password other than "0000."
The unit and device are too far
apart.
There is a device (microwave
oven, wireless LAN, etc.) that
outputs signals in the 2.4 GHz
frequency band nearby.
Another device is
connected.
Cannot make a Another device is
Bluetooth
connected.
connection.
More than nine devices are paired
and the oldest pairing information
is deleted.
Cannot make a There is a problem within the unit.
Bluetooth
connection (the
BLUETOOTH
indicator
continues to
flash rapidly).
Remedy
Select as the input source.
Perform pairing operations with a
device which supports A2DP.
Use a adaptor, etc., whose
password is "0000."
Move the device closer to the unit.
Move the unit away from the device
that is emitting radio frequency
signals.
If the device is equipped
with the wireless LAN function, turn off
the wireless LAN function, and turn on
the function only.
Terminate current
connection, and perform pairing with
the new device.
The unit cannot make multiple
connections. Terminate
current connection, and
make connection for the desired
device.
Perform pairing again. The unit can
retain pairing information for up to
eight devices. When pairing a ninth
device, pairing data for the device with
the oldest connection date will be
deleted.
Unplug the power cable from the AC
wall outlet and contact the nearest
authorized Yamaha dealer or service
center.
No sound is The connection of the
unit with the device is
produced or the
disconnected.
sound is
interrupted
is not selected as the
during playback.
input source.
The unit and device are too far
apart.
There is a device (microwave
oven, wireless LAN, etc.) that
outputs signals in the 2.4 GHz
frequency band nearby.
The device is not set to send
audio signals to the
unit.
Playback on the device has not
been performed.
The device's volume is set to
minimum.
Perform connection
operations again (p.10).
Select as the input source.
Move the device closer to the unit.
Move the unit away from the device
that is emitting radio frequency
signals.
If the device is equipped
with the wireless LAN function, turn off
the wireless LAN function, and turn on
the function only.
Change the audio output setting and
connection setting on the device.
Perform playback on the device.
Turn up the device's volume level.
17