Troubleshooting - Yamaha SRT-700 Bedienungsanleitung

Troubleshooting

Refer to the table below when the unit does not function properly. If the problem you are
experiencing is not listed below or if the instructions below do not help, turn off the unit,
disconnect the power cable, and contact the nearest authorized Yamaha dealer or
service center.
First, check the following:
A The power cables of the unit, TV and playback devices (such as BD players)
are connected to AC wall outlets securely.
B The unit, TV and playback devices (such as BD players) are turned on.
C The connectors of each cable are securely inserted into jacks on each device.
Power and system
Problem Cause
The power turns The auto power standby function
off suddenly. worked.
When the auto power standby
function is enabled and one of the
following conditions is met, the
unit will automatically turn off.
- No operations for 8 hours
- No audio input and no
operations for 20 minutes when
BLUETOOTH is selected as the
input source.
The protection circuitry has been
activated. (The D indicator on
the front panel of the unit flashes.)
connection is
terminated on a
when the standby mode
is enabled.
The power The protection circuitry has been
activated three times
cannot be turned
consecutively. (If you try to turn on
on.
the power in this condition, the
D indicator on the front panel of
the unit flashes.)
Remedy
Turn on the unit again. To stop the unit
from turning off automatically, disable
the auto power standby function
(p.14).
After confirming that all connections
are made properly, turn on the unit
again. If the power often suddenly
turns off, unplug the power cable from
the AC wall outlet and contact the
nearest authorized Yamaha dealer or
service center.
Disable the standby mode
device (p.11).
To protect the product, the power
cannot be turned on. Unplug the
power cable from the AC wall outlet
and contact the nearest authorized
Yamaha dealer or service center.
All indicators go The brightness of indicators is set
to off on the DIMMER key setting.
out although the
unit is turned on
(it may seem that
the unit is turned
off).
The unit is not The internal microcomputer is
responding frozen, due to an external electric
shock (such as lightning or
correctly.
excessive static electricity) or to a
drop in the power supply voltage.
The unit Another device is being
operated nearby.
operates by
itself.
The unit cannot The device on which
be operated the application has been installed
is not connected to the unit.
using the
dedicated
application
"HOME
THEATER
CONTROLLER."
(The screen of
the application
does not shift
from the demo
mode.)
Audio
Problem Cause
No sound. Another input source is selected.
The mute function is activated.
The volume is too low.
The power cable of the unit is not
connected properly.
Input jacks on both devices are
connected.
Signals that the unit cannot play
back are being input.
Operate the DIMMER key to select the
desired brightness (p.9).
Hold down (power) on the front
panel of the unit for more than 10
seconds to reboot it. (If the problem
persists, unplug the power cable from
the AC wall outlet and plug it again.)
Terminate connection of the
unit (p.11).
Connect the device and the
unit via and use the
application.
Remedy
Select an appropriate input source
(p.8).
Cancel the mute function (p.9).
Turn up the volume (p.8).
Make sure that the power cable of the
unit is connected to an AC wall outlet
securely (p.6).
Connect the input jack on the unit and
the output jack on the external
playback device.
Change the digital audio output setting
on the playback device to PCM or
Dolby Digital.
15