Fiap profinet FishTrap 2-fold Gebrauchsanweisung Seite 5

GB FISH TRAPS & BASKETS
STEP 2
Insert the two shorter weight rods into the designated holders on the Type 2 body and
the longer ones into Type 1. Secure the rods to the Clip side with cable ties.
STEP 3
Place the Type 2 body with the smaller diameter on the ground. Place a board under the
body to prevent the hooks from touching the ground and cancel.
STEP 4
Place the intermediate ring on the body type 2 with the article number facing up and the
small recesses towards the hooks.
STEP 5
Before installing the Type 2 throat, you have the option of expanding the opening by
cutting it off, for example to catch smelt or larger eels. Place the type 2 throat on the
intermediate ring so that the hooks reach through the corresponding recesses. Make
sure that all parts fit tightly together. Lock the Type 2 throat by turning it to the right.
Danger! Selecting the correct recesses is important, otherwise the next assembly step
cannot be carried out.
STEP 6
Insert the hooks of the Type 1 body into the corresponding recesses of the Type 2 body
and connect the parts by turning them to the right. Make sure that the iron bars face
each other afterwards.
STEP 7
Secure the connection with 4 cable ties.
STEP 8
Now insert the throat type 1 into the upper part of the body.
STEP 9
The type 1 inlet is then placed on the hooks and locked by turning it to the right.
STEP 10
Secure the connection with 4 cable ties.
STEP 11
Now place the fish trap on the ground with the inlet facing down and place the end piece
on the hooks. The connection is made by turning to the right.
STEP 12
Secure the connection with 3 cable ties.
STEP 13
Insert the cap with the bait basket and screw it on.
STEP 14
To attach the anchor rope, you can pull a 6-8 mm thick line through the hole and knot it.
5
The cap handle should NOT be used for this.