GET BOOST Handbuch Seite 4

C. GET BOOST INSTALLATION
REMEMBER TO OPERATE IN SAFE CONDITIONS AND
KEEP THE ENGINE OFF.
1.
Remove the seat, the fuel
tank, and both front side
panels. Position the GET
wiring harness, keeping the
main connector (A) facing
the engine head.
2.
Insert the GET Boost
module into the dedicated
rubber support supplied in
the kit. Connect the main
connector of the GET wiring
harness (A) to the GET Boost
connector.
3.
Secure the GET BOOST
module to the frame on the
left side of the motorcycle as
shown in the figure.
Position it on the inside of
the frame (behind the rubber
guard) and fasten it with two
zip ties. Make sure the GET
BOOST module connector is
oriented upward.
EN
4
Towards
engine
A
head
A
Main
connector
of the GET
wiring
harness