Herunterladen Inhalt Inhalt Diese Seite drucken

Connection Requirements - Clatronic HDR 2941 Bedienungsanleitung, Garantie

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
GB
Remove the motor device and the accessories from the box. Also remove any
packaging materials that may be present.
High-Pressure Hose (7)
Connect the high-pressure hose (7) to the high-pressure outlet (2). Turn the con-
nection in a clockwise direction until it his hand tight on the screw thread.
Standpipe
The standpipe (4) can only be screwed on to the hand spray gun (8). Turn the
standpipe in a clockwise direction until it his hand tight on the hand spray gun.
Jet pipe with nozzle
The jet pipe (5) with nozzle can only be attached to the standpipe (4). These
components have a quick-acting closure (13).
The connection is locked by pressing and turning simultaneously in a clockwi-
se direction.
The connection is opened by fi rst pressing the components together and then
turning the pipe in an anticlockwise direction.
Detergent Container
The detergent vessel can only be attached to the high-pressure nozzle (11).
Before you can attach the detergent vessel it is necessary to turn the two plates in
the nozzle together by turning the high-pressure nozzle (11).
The detergent container consists of 2 components.
1. Connection with nozzle. Affi x the connection to the high-pressure nozzle (11)
and press it using small up-and-down movements until the catch locks into
place on the nozzle. Release the connection by lifting the catch.
2. The container. After fi lling this is attached to the connection and locked into
place by means of a short twist in a clockwise direction.
Electrical connection
Only connect the machine to a properly installed safety socket, 230 V/50 Hz.
Before inserting the mains lead into the socket, check whether the voltage you
intend to use complies with that of the machine.
Extension Leads
Only extension leads that are protected against water spray should be used with
high mechanical strength and an internal diameter of at least 3 x 1.5 mm
62
6....-05-HDR 2941 62
Assembly

Connection Requirements

2
.
07.01.2005, 14:32:16 Uhr

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis