Ispring RCD100 Installations- Und Bedienungsanleitung Seite 9

Other notes:
1. Initial system startup: The system will initiate a ush sequence upon rst-time use. The ush
will take 120 seconds. The system will also ush for 30 seconds each time after water has
been dispensed and 10 seconds after the water tank has been lled.
Sleep Mode: The system will automatically enter sleep mode after 5 minutes of inactivity. All
2.
displays/lights will be turned o . Press any button to exit sleep mode.
3. Filter life indicator: The 4 bars on the indicator represent
the lter life with a white backlight. When a particular
lter reaches the end of its life cycle and must be replaced
or serviced, the correspondent lter life indicator light will
ash red with 30 beeps until it is reset. IT IS STRONGLY
RECOMMENDED TO FOLLOW THE INDICATOR ON
FILTER REPLACEMENTS/SERVICE, OR THE WARRANTY
MAY BE VOIDED.
4. Filter Life Indicator Reset: See the description from the table above in the "Option" section.
5. Temperature Unit Change: Press and hold the "Option" button for 3 seconds or until the
"beep" sounds to switch between Celsius and Fahrenheit.
6. System factory reset: To reset the system to factory settings, remove the lid of the water
tank, press and hold the "Setting" and "Room Temp." buttons for 5 seconds or until a long
"beep." This will erase all user settings and reset lter life indicators. Each time the system is
reconnected to the power supply or after reset, it must dispense room-temperature water
for 10 seconds before hot water modes can be used.
08