Ispring RCD100 Installations- Und Bedienungsanleitung Seite 8

Parameter
Press and hold this button for 3 seconds or until a "beep" sound plays to enter the
Setting
lter life reset mode.
After entering the lter reset function, use press this button to choose a speci c
stage of the lter to reset the lter life. Please note that the lter reset must be done
while the tank lid is closed. The numbers 1, 2, 3, and 4 each represent a particular
lter-1 for the FNF100 Stainless mesh lter, 2 for the FPC100 composite lter, 3 for
Option the MCD100 RO membrane, 4 for the FCB100 post-activated carbon lter. The
number logo will ash after being chosen. Press and hold the "Setting" button until
a "beep" sound to rest the lter after replacing the cartridge. Repeat the above
steps to reset all lters when needed. The reset mode will end automatically after 5
seconds of inactivity. The backlight should ash after a beep each time it is pressed.
Press this button once to disengage the Children's Safety Lock (CFL). The CFL will
automatically engage and apply to all hot water modes (Formula, Co ee, Tea) after
Lock
5 seconds of inactivity. "Room Temp." mode is NOT governed by the CFL.
Press this button to dispense room-temperature water. Press the same button to
stop. A maximum 0.06 gallons (250 ml) of water will be dispensed per cycle.
Room Temp. Press and hold this button to override the cycle limit and dispense water
continuously or until the ltered water tank is empty, whichever comes rst. Press
this button again to exit override mode.
After disengaging the Children's Safety Lock (CFL), press this button to dispense
120°F (50°C) water. A maximum of 0.06 gallons (250 ml) water will be dispensed per
Formula
cycle.
After disengaging the Children's Safety Lock (CFL), press this button to dispense
185°F (85°C) water. A maximum of 0.06 gallons (250ml) water will be dispensed per
Co ee
cycle.
After disengaging the Children's Safety Lock (CFL), press this button to dispense
205°F (95°C) water. A maximum of 0.06 gallons (250 ml) water will be dispensed per
Tea
cycle.
WORK
This light ashes when the system produces pure water.
REFILL This light ashes when the system produces pure water.
This signal keeps ashing when the system encounters issues that need attention.
See the "Troubleshooting" section for details.
This signal is always on when the UV is working and goes out after the sterilization.
When the system is powered on, the UV will automatically turn on and work, and it
UV
will automatically run the cycle of turning on for 10 minutes and turn o for 20
minutes.
Speci cation
07