Filter Installation And Replacement - Ispring Rcd100 Installations- Und Bedienungsanleitung

Note:
•
Rinse the tank and replace the water if not used for more than 24 hours.
•
Do not ll the tank with any liquid other than water.
•
Every time you open the cap, please wait 10 seconds before removing the tank.
Filter installation:
1. Place the system on a stable and leveled surface and remove the packaging on the lters.
2. Open the water tank cap and lift the tank. Rinse the tank thoroughly.
3. Place the 1st stage FNF100 stainless steel mesh lter onto the slot in the bottom of the tank
on the right side.
4. The 4 stage FCB100 lter slot is behind the 2nd and 3rd lters; therefore, it must be installed
rst. Just insert the lter into the slot on the wall with the label facing up, and make sure the
lter goes all the way into the slot.
5. The 2nd stage FPC100 lter should be installed at the left half of the wall behind the tank.
Lift the lter cap on the system, insert the lter, and plug it into the slot; slightly twist the
lter counterclockwise until the lter seats in tightly and the mark on the lter aligns with
the arrow on the lter cap. Perform the same operation for the 3rd stage MCD100 RO
membrane on the right portion of the system wall.
6. Place the tank back in the base, ll up the tank, and close the lid. The system WILL NOT
operate with the lid open. Make sure the surface and system are dry. Plug the adapter into
the power outlet. The display will turn on with a "beep" sound, indicating that the system is
on.

Filter Installation and replacement

09