Label Application; Paddle Shifter Force Setting - Ascher Racing F28-Sc V2 Produktanleitung

8. Label Application

encoder knobs must be removed to apply label (hex wrench)
-
to apply button labels the easiest way use a tool such as a knife
-
put the label on the very tip of the knife
-
position label centered and horizontal
-
press the label on the surface
-

9. Paddle Shifter Force Setting

paddle shifter snap action force is set by the combination of magnets and spacers
-
do not let magnets smash into each other – magnets are very brittle and can break
-
to pull out installed magnets, put additional magnets carefully on top
-
press the paddle shifter to separate installed magnets
-
pull out top and bottom magnet
-
magnets can be separated the best by shearing them off
-
4 pcs 3mm magnets & spacers can be found in the packaging foam insert
-
approx. actuation force depending on magnet height and spacers:
-
•
800g = 5mm + 5mm (factory default)
•
570g = 5mm + 5mm + 1 spacer
•
480g = 3mm + 3mm
•
440g = 5mm + 5mm + 2 spacers
•
340g = 3mm + 3mm + 1 spacer
•
260g = 3mm + 3mm + 2 spacers
ENGLISH | GERMAN
8 | p a g e