Maintenance; Operation - Makita BST110 Bedienungsanleitung

Remove the battery cartridge.
Press the locking lever and slide the magazine back.
Take out staples from the magazine slit.
Hook
CAUTION:
Always make sure that your fingers are not placed
•
on the trigger or the lever and the battery cartridge
is removed before using the hook.
Fig.8
CAUTION:
Do not hang the hook from the waist belt. Dropping
•
the stapler, which is caused by the hook
accidentally coming out of place, may cause
misfiring and personal injuries.
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
Fig.9

OPERATION

Driving staples
WARNING:
Before pulling the trigger, always make sure that
•
the opening from which staples are fired contacts
material to be fastened. Just pulling the trigger fires
staples. Misfiring may cause personal injuries.
Fig.10
Place flat the opening of the tool from which staples are
fired on the material to be fastened and hold the tool
firmly against the material. Then pull the lever and then
pull the trigger fully to drive the staples. The grip is
shaped so that the tool head can be held down securely
with index finger and thumb. After driving a staple, be
sure to release the trigger fully.
When the head of driven staple remains above the
surface of material to be fastened, drive the staple while
holding the stapler head firmly.
Fig.11
NOTE:
When the trigger is pulled after a quick trigger
•
action, the stapler may do nothing but operates
momentarily and may not fire staples. This is not a
trouble. At this time, release the trigger once, pull it
again and the staples can be fired.
Using the stapler continuously with the head of
•
driven staples remaining above the surface of
material to be fastened may cause damage to the
driver of the stapler and stapler jamming etc..
Checking remaining staples
Fig.12
Remaining staples can be checked through the
finestella.
New staples can be loaded when the pusher is seen in
the center of the finestella.
Removing jammed staples
WARNING:
Always make sure that the lever and trigger are
•
released and the battery cartridge is removed
before removing jammed staples .
Remove the battery cartridge from the stapler.
Fig.13
Press the locking lever on the rear of the sub magazine
and slide the sub magazine backward.
Take out stuck staples that remain inside the opening
that staples are fired from as it appears.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
To maintain product SAFETY and RELIABILITY,
•
repairs, any other maintenance or adjustment
should be performed by Makita Authorized Service
Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Staples
•
Various type of Makita genuine batteries and
•
chargers
Safety goggles
•
6
or attachments
Only use accessory or
are