Seite 1
Electronic Hi-Fi Record-player 22AF829/50 Met dank aan www.radiomuseum-hengelo.nl Service NedaVer. v. Historie v/d Radio ARCHIEF DOCUMENTATIEDIEN NVHR Service Manual 110-127-220-240V 50/60Hz Zz&•---- 22GP1+00 r 22GPL01 22GP406T 22GPL12r 22GP WOW AND FLUTTER. s 0.05% PLAY/CUT STOP LOCK INDICATION SENSOR LED1468 LED467...
Seite 2
MECHANICAL ADJUSTMENTS REGLAGES D'ORDRES MECANIQUE TURNTABLE HEIGHT HAUTEUR DU PLATEAU Fig. 1 BOWDEN CABLE POS. 150 Ll FT MANUAL CABLE BOWDEN POS. 150 LEVIER MANUEL O mm RECORD DISQUE KNOB155 | 0—0.5mm POSITION BOUTON 155J 17766BZ Fig. 3 Fig. 2 70 731...
Seite 3
FREE RUNNING P.U. ARM POS. 137 SELECTION BRACKET LIBERATION DU BRAS DE LECTURE POS. 137 ETRIER SELECTEUR Gill} QBmm 6 mm FOR CORRECT SETTING- DOWN t7cm RECORD IN PwTlON POUR Pose PRfC)SE D!SOv€ P.U ARM REST CORRECT SETTING- DOWN ON 30em RECORD LEVIER EN FOSITION...
ELECTRICAL ADJUSTMENTS Set the record player to 33 r.p.m. If the motor fails to start, check the motor by applying 1. E n the 33 or 45 r.p.m. position, the supply voltage +2 approx. 2 V d.c- to the motor. must be 11 V with respect to chassis, adjustable with If the motor now runs, check the tacho•generator under-...
Seite 5
KONTROLE "DIRECT MOTOR CONTROL" Breng de draaitafel met de hand aan het draaien. QP de punten 12 en 14 van IC427 moet nu een blok- 0m zonder draaitafel de werking van de platenspeler vormige spanning van V met een frequentie afhankelijk te kontroleren, moet men op de printzijda een con- van de snelheid van draaitafel aanwe2ig zijn.
Seite 6
Voir point Si Ie résurtat est toujours insatisfaisant, contröler I'lC428a et procéder comme suit: Vérifier å présent les points Brancher une groupe alimentation extérieur d'une tension l'aid d'une sond deforte puissanc ohmique VDC sur le point 6 de I'lC428a. Le point 7 de I'lC428a doit présenter 10:1 dioscilloscope.
Seite 7
Mattere b'apparecchio in posizione 33 r.p.m. REGOLAZIONI ELETTRICHE Se il motore non gira, verificare anzitutto i! motore stesso I, In posizione 33 ou 45 giri/min. la tensione di alimen- applicando una tensione continua di ± 2 V, tazione +2 nei confronti del chassis deve essere di 11 V Se il motore gira, verificare il generatore sotto il piatto...