Setting Of The Clock - Tfa Soluna Mini Bedienungsanleitung

TFA_No. 60.2050_Anleitung 25.08.2025
Light alarm clock with mood light
• Make sure the polarities are correct. Remove the batteries if the device will not be used for an extended period of
time. Avoid contact with skin, eyes and mucous membranes when handling leaking batteries. In case of contact,
immediately rinse the affected areas with water and consult a doctor.
CAUTION!
Important information on product safety!
• Do not expose the device to extreme temperatures, vibrations or shocks.
• Clean the device with a soft damp cloth. Do not use solvents or scouring agents.
• Pull out the plug of the socket if the device will not be used for an extended period of time.
• Store the device in a dry place.
5. Elements
A: Display (Fig. 1):
A 1: Time / wake up time
A 2: Alarm symbol
A 3: Snooze symbol
A 4: Sleep timer symbol
A 5: Battery symbol
A 6: PM in 12-hour format
A 7: AM in 12-hour format
B: Buttons (Fig. 1+2):
B 1: NIGHT LIGHT sensor button
B 2: LIGHT button
B 3: – button
B 4: SNOOZE/DISPLAY button
B 5: + button
B 6: TIMER/SET button
B 7: ALARM button
16
14:28 Uhr Seite 9
Light alarm clock with mood light
C: Housing (Fig. 1+2):
C 1: Mood light
C 2: USB-A port for charging function for mobile devices
C 3: Battery compartment
C 4: USB-C port for power supply
C 5: Speaker
6. Getting started
• Plug the supplied USB-cable into the designated ports on the device (USB-C) and mains adapter (USB-A). Connect
the device with the power supply to the mains. Important! Make sure that your household voltage is no more than
240V! Otherwise your device may be damaged.
• Optional: Open the battery compartment and insert two new AAA 1.5 V batteries, polarity as illustrated. The batteries
maintain the function in the event of a power failure, so that no readjustment has to be made and the settings are
retained. For permanent illumination, use of all light functions, the charging function and to extend the battery life,
please use the supplied USB cable for the power supply.
• Close the battery compartment.
• The device will alert you with a beep and all LCD segments will be displayed for a short moment.
• Note: If no batteries are inserted, the battery symbol appears permanently on the display.
7. Operation

7.1 Setting of the clock

• Press the TIMER/SET button for 3 seconds to enter the setting mode.
• The first adjustable value flashes on the display.
• Use the + or - button to make the desired setting, while the value flashes.
• Confirm with the TIMER/SET button and go to the next setting.
• The sequence is shown as follows:
– 24/12-hour format (default: 24HR)
– Hour, minutes
• Press the TIMER/SET button to confirm the setting or wait 10 seconds, the unit will save the setting automatically.
• Notes: Press and hold the + or – button in setting mode for fast mode.
• Press the SNOOZE/DISPLAY button in setting mode to return to normal mode.
17