Humberg MB1 Bedienungsanleitung Seite 5

Regulation
Proper adjustment of the wheel holders to the size of the wheels on the bicycle is crucial
to protect it from tipping over. If you change your bicycle, readjust the rack.
Using an M5 wrench, pop the M6x20 screws loca-
1
ted on the back of the wheel holder.
Using the markings that are located on the right
side of the stand, adjust the holder to the wheel
size and retighten the screws.
Using an M5 wrench, pop the M6x20
2
screws located on the back of the wheel
holder. Drive the wheel onto the stand
so that it touches the rear and middle
bracket. Slide the top bracket so that it
touches the wheel and then re-tighten
the screws.
Usage
vertical option
(hanger)
1
pozycja dla koła 20" - 22"
pozycja dla koła 24" - 29"
horizontal option
(stand)
2
5