Tetra EX 400 Plus Bedienungsanleitung Seite 8

EN
How to proceed:
A G
1. Place the filter media securing plate, filter media
containers and filter media into the filter case in the
correct order.
–
Align the filter media securing plate and filter me-
dia containers such that the arrows point in the
same direction as the arrow on the filter case.
2. Close the filter ( Fitting the motor head).
Connecting the hose to the hose adapter
The procedure is identical for the inlet IN and outlet
OUT.
How to proceed:
H
1. Fit the stop valve onto the hose adapter connection
and turn the nut clockwise by hand.
2. Fit the hose onto the hose connection socket.
3. Turn the union nut for securing the hose counter-
clockwise.
Fitting the intake pipe and outlet pipe
How to proceed:
B I
1. Assemble the intake pipe as shown and fasten it with
the suction cups vertically to the inside wall of the
aquarium,
2. Assemble the outlet pipe as shown and fasten it with
the suction cups horizontally above the surface of the
water to the inside wall of the aquarium,
–
Shorten the outlet pipe if necessary.
3. Connect the hose from the inlet IN of the filter to the
intake pipe.
4. Connect the hose from the outlet OUT of the filter to
the outlet pipe.
N O T E
Kinks or twists in the hose impair the function of the fil-
ter.
 Route the hose without kinks and twists.
 Shorten the hose if necessary.
8
Positioning the filter
J
Position the filter at the specified distance from the level
of the water in the aquarium to avoid malfunctions of
the filter.
Filter
EX 400 Plus
EX 600 Plus
EX 800 Plus
EX 1200 Plus
START-UP
W A R N I N G
Dangerous electrical voltage!
Death or severe injury from electrocution.
 Only connect the plug to a correctly installed power
socket.
 Never connect the plug to the power socket if the
filter, hoses, cord or plug are damaged.
N O T E
The pump must never run dry. The pump will be de-
stroyed.
 Regularly check the water level and circulation in
the filter and in the aquarium.
N O T E
Risk of water damage due to leaking hoses.
 Immediately check all hoses and connections for
leaks after starting up the filter.
 If there are any leaks, immediately disconnect the
plug and close the stop valves.
 Do not start up the filter again until all leaks have
been eliminated.
 Check for leaks again when the filter has been oper-
ating for approx. 30 minutes.
Distance A
40 ... 150 cm
50 ... 150 cm
60 ... 150 cm
80 ... 150 cm