Installation And Connection - Tetra EX 400 Plus Bedienungsanleitung

Intended use
EX 400 Plus, EX 600 Plus, EX 800 Plus, EX 1200 Plus may
only be used as specified in the following:
 For cleaning aquarium water.
 For operation with freshwater or saltwater.
 Operation under observance of the technical data.
The following restrictions apply to the appliance:
 Only operate with water at a temperature of +4 °C ...
+35 °C.
 Only install the appliance outside of the aquarium.
Never place it into the water.
 Only use indoors.
 Only use for aquaristic purposes in the home (not for
commercial use).
ACCESSING THE FILTER
Removing the hose adapter
The hose adapter is removed before taking off the motor
head.
Prerequisite:
 The plug is disconnected from the power supply.
 Both stop valves are closed.
How to proceed:
C
1. Hinge up the cover on the hose adapter.
2. Hinge up the locking lever and turn it as far as it goes
into the position "lock open".
3. Pull the hose adapter off the motor head.
Fitting the hose adapter
How to proceed:
D
1. Hinge up the cover on the hose adapter.
2. Turn the locking lever into the position "lock open".
3. Fit the hose adapter into the intended recess and
press it into the motor head as far as it goes.
4. Turn the locking lever into the position "lock closed"
as far as it goes and hinge down.
5. Hinge down the cover.
Removing the motor head
The motor head is removed for cleaning and mainte-
nance, and for changing the filter media.
Prerequisite:
 The hose adapter has been removed. ( Removing
the hose adapter)
How to proceed:
E
1. Lift and release all four locking clips on the filter
case.
2. Hinge down the locking clips.
3. Remove the motor head.
Fitting the motor head
How to proceed:
F
1. Align the motor head such that the pipe is positioned
over the opening of the filter media securing plate.
2. Fit the motor head onto the filter case and fasten with
the four locking clips.
3. Fit the hose adapter. ( Fitting the hose adapter)

INSTALLATION AND CONNECTION

Prepare the filter media
Some of the filter media is packaged on delivery. It has
to be removed from the packaging and rinsed.
Prerequisite:
 The motor head has been removed. ( Removing the
motor head)
How to proceed:
A
1. Remove the filter media securing plate, all filter me-
dia containers and filter media from the filter case.
2. Unpack the filter media, dispose of the packaging in
an environmentally friendly manner.
3. Thoroughly rinse all the filter media with warm tap
water.
Filling the filter case with filter media
The filter case has to be filled with the filter media in the
correct order.
Prerequisite:
 The motor head has been removed. ( Removing the
motor head)
 The filter media is prepared. ( Prepare the filter
media)
EN
7