Nordcap RC600 Benutzerhandbuch Seite 6

r-
To do so, proceed as follows:
1. Switch off power at the mains socket. Remove the top panel and disconnect the
multiplug inside.
2. Remove the hinge pin, and lift off the door.
3. Move hinge from one side to the other.
4. Move the handle from one side to the other.
5. Place the door in the hinge on the desired side. Insert hinge pin in the hinge and in
the door hinge bush. Fasten the hinge.
6. Connect the multiplug to the panel, and fasten the panel. Resume power to the
cabinet.
Troubleshooting
If your RCX00/RNX00 appliance is not functioning properly, please check the follow-
ing table before calling the Helpline.
Fault Probable Cause Action
The appliance
is not
working
The unit is not switched on Check that the unit is plugged in
correctly and switched on
Plug and/or lead are damaged Call our agent or qualified
technician
Fuse in the plug has blown Replace the fuse
Power supply Check power supply
Internal wiring fault Call our agent or qualified
technician
The appliance
turns on, but
the
temperature
is too
high/low
Too much ice on the condenser Defrost the appliance
Condenser blocked with dust Clean the condenser thoroughly
Doors are not shut properly Check that doors are shut and
seals are not damaged
Appliance is located near a heat
source, or air flow to the
condenser is blocked
Move the refrigerator to a more
suitable location
Ambient temperature is too high Increase ventilation or move
appliance to a cooler position
Unsuitable foodstuffs are being
stored in the
appliance
Remove any excessive hot
foodstuffs or blockages to the fan
Appliance is overloaded Reduce the amount of food stored
in the appliance
The appliance
is leaking
water
The appliance is not properly
leveled
Adjust the screw feet to level the
appliance
The discharge outlet is blocked Clear the discharge outlet
Movement of water to the drain
is obstructed
Clear the floor of the appliance
The water container is damaged Call our agent or qualified
technician
The drip tray is overflowing Empty the drip tray
The appliance
is unusually
loud
The frame has become loose Check and tighten all nuts and
screws
The appliance has not been
installed in a level or
stable position
Check installation position and
change if necessary
Cleaning
ABefore
cleaning, switch off the cabinet at the mains.
The cabinet should be kept clean using a mild soap solution. Do not use abrasive
cleansers. The plastic parts cannot withstand boiling water (max. temperature +85°C).
When regular cleaning is performed, be sure to wipe clean the rubber door gasket to
ensure any sticky substances are removed that would otherwise damage the gasket.
The condenser fan air outlet above the compressor must be free of leaves, paper etc.
to ensure normal operation of the cabinet.
The condenser on the back of the cabinet must be regularly cleaned as well. This is
best done with a vacuum cleaner and a brush.
N3posal
If the cabinet is no longer of use and you wish to dispose of it, please do so in an
environmentally correct way. There may be special requirements or conditions.
You can obtain information on the disposal of refrigeration appliances from:
- Your supplier
- Government authorities (The local council, Ministry of the Environment, etc.)