Power Requirements; Temperature Setting - Nordcap Rc600 Benutzerhandbuch

Warning - This appliance must be earthed
The flexible cord fitted to this appliance has three cores for use with a 3-pin 13 Amp plug. If a B.B. 1363
(13 Amp) fused plug is used, it should be fitted with a 13 Amp fuse or a moulded right-angled Schuko
plug. Note the plate with a hole in it between and above the two pins - this connects to French and
Belgian sockets, which have an earth pin that sticks out. Running in a slot coming from that plate is a
continuation strip from the plage. Other european countries use a socket with a scrolled metal connec-
tor emerging from the side which mates with that strip. This ensures that the Schuko can be used in
most mainland european countries.
Important
The wires in this mains lead are coloured in accordance with the following code:
Green-and-yellow: earth
Blue: neutral
Brown: live
Servicing:
Make sure the appliance is switched off at the mains before service is
performed on electrical parts.
Never use a sharp or pointed object that may damage the freezer.
Power Requirements
The cabinet is intended for connection to an alternating current. The connection
voltage (V) and frequency (Hz) are shown on the nameplate in the cabinet.
The power connection is made using a three-pin plug to a wall socket.
Any requirement for earthing from the local power supply must be met. The cabinet
plug and wall socket should then give a correct earthing. If you are in doubt, contact
your local supplier or authorized electrician.
The colours of the wires in the mains lead of this appliance might not correspond with
the coloured markings identifying the terminals in your plug.
Proceed as follows:
The wire which is coloured green-and-yellow must be connected to the terminal in the
plug which is marked "E", marked by the earth symbol or coloured green-and-yellow.
The wire, which is coloured blue, must be connected to the terminal, which is marked
with the letter "N", or coloured black.
he wire which is coloured brown must be connected to the terminal which is marked
with the letter
"L"
or coloured red.
Temperature Setting
Temperature control:
Each refrigerating appliance is provided with a thermostat that automatically main-
tains the appropriate pre-established temperature inside the tank. This temperature
adjuster is gauged by the factory and should not be touched by the user. Only if the
average internal temperature is too cold or not cold enough should the knob turned.
Defrosting
Procedure
RCX®O:
Electric Defrosting using automatic water evaporation.
RNX®®:
Disconnet main power cord and wait internal ice to be melted.
Startin ^ itr)p
Lock
Plug in the cabinet.
The display shows the actual cabinet temperature
Thermostat Display
Cha; cgi tcg al
Door Hinge
The door can be changed from right hand-hinged to left hand-hinged, or vice versa.
6 7