Teaching-In Without A Brightness Threshold - HomeMatic HM-Sen-MDIR-O Bedienungsanleitung

HomeMatic actuators, such as wireless switches. To
execute the teach-in procedure, the devices to be
connected must be in teach-in mode. The device can
be taught-in both without a brightness threshold (i.e.
switching in brightness too) and with a fixed brightness
switching threshold of approx. 10 lux (switching only in
twilight/darkness). The device operates with a minimum
transmission interval of 4 min. When directly teaching in
the device to a HomeMatic actuator, the duty cyctle of
the HomeMatic acutator will be set to 5 min. Thus, e.g.
an a interruption-free illumination during longer lasting
movement is possible. It is possible to configure the
response brightness and response sensitivity as well
as the minimum transmission interval or futher settings
of the device from the HomeMatic central control unit.

8.1.1 Teaching-in without a brightness threshold

• Remove the device from the wall mount (F) and
open the battery compartment (E).
• Press the teach-in button (D) on the HomeMatic
wireless infrared motion detector. The device
LED flashes orange. The teach-in procedure can
now be cancelled by pressing the teach-in button
(D) briefly; this will cause the device LED to light
up red.
• The device LED flashes green to indicate that
43