Configuring The Ip Dect Server; Network Settings - comfortel WS-400 IP Betriebsanleitung

determine the IP addresses either via the DHCP Server and the
IP DECT Server's MAC address or via UPnP.
If no DHCP Server has been set up, the static IP address
192.168.0.1 and the network mask 255.255.255.0 are used
instead after a waiting time of approx. 1.5 minutes.
– Knowledge of the access data (see chapter Commissioning
> Default settings when the equipment is supplied).
Start a browser (e. g. Mozilla Firefox).
1.
Enter the IP DECT Server's IP address (e. g. http://
2.
192.168.0.1) in the browser's address bar.
Enter the user name in the User name entry field.
3.
Enter the password in the Password entry field.
4.
Click OK.
5.

Configuring the IP DECT Server

Requirements
– PBX with the following features:
available internal VoIP channels
configured internal SIP subscribers (telephone number,
user name, PIN/password)

Network settings

Open the Configuration > General page.
1.
Select one of the following options from the Method list field
2.
displayed under IPv4:
Use Static IP Address: The IP DECT Server is assigned
a fixed IP address (recommended).
DHCP assigned: The IP DECT Server gets its IP address
automatically from a DHCP Server.
Only for Use Static IP address:
3.
Enter the IP DECT Server's IP address in the IP addr
entry field.
Enter the network mask in the Netmask entry field.
Enter the gateway name in the Gateway entry field.
Under NTP, enter the NTP Server's IP address in the Server
4.
entry field.
COMfortel WS-400 IP - Instructions V05 06/2017
Commissioning
25