Weather Forecast - Technisat Imeteo 210 Betriebsanleitung

While adjusting the value, press and hold the + or - button to quickly adjust.
-
Press the SET button to confirm the last item to complete the setting
-
procedures, and then returns to normal mode.
- If the 12-hour format is selected, if "PM" is displayed before the time, it
means the time is in the afternoon.
Tip
- If no important operation is performed within 20 seconds, the device will
automatically return to normal time mode from the set mode.
4.3 RF transmission
- The main unit will automatically start receiving transmissions from the
remote temperature and humidity sensor after inserting batteries.
- The remote sensor will automatically send temperature and
humidity data to the main unit when the battery is inserted.
- If the main unit does not receive transmission from the remote sensor
(the LCD display will show "- -.-" and "--").
Tip:
- When a low battery warning signal is received from the transmitter, a flashing
low battery symbol will be displayed
4.4 Minimum and maximum value memory
- When the temperature and humidity are displayed on the LCD, the main unit
began to record the maximum and minimum numerical value of temperature
/ humidity.
Press the MEM button once, the LCD will display the maximum
-
temperature/humidity value, the LCD will display the minimum
temperature/humidity value, if you press the MEM button again when the
maximum value is displayed.
- At the same time, the LCD display will show "MAX" or "MIN".
The maximum / minimum value will be saved when the MEM button
-
is pressed and held for 3 seconds.
The day memory value will be automatically cleared at 0:00 each night.

4.5 Weather forecast

Warning: consider the weather forecast from your local weather
forecasting service, as well as the forecast from the weather station. In case of
discrepancies between the information from the device and the information
from the local weather service, the recommendations of this
6
.