Setting The Clock - Technisat Imeteo 210 Betriebsanleitung

7. Battery cover
8. Control buttons
4 First configuration of the device
4.1 Switching on the weather station for the first time
- Please connect the power cord to the power socket of the weather station (6)
Then connect the DC 5V power adapter to the power socket.
or
Please remove the battery cover, install two 1.5V AAA (LR03) batteries and close
the battery cover. When installing, please pay attention to the correct polarity.
- After inserting the battery or connecting the DC 5V power supply, all
icons on the LCD display will light up for 3 seconds, and then the room
temperature and humidity will be checked.
- The station will start connecting to the external temperature/humidity sensor.
This process takes a maximum of 3 minutes and will be displayed in the
upper right corner with a flashing receiving antenna symbol .
- At this point, open the battery compartment cover of the remote sensor,
insert 2 AAA batteries according to the correct polarity (see "+" and "-"
markings) and close the battery cover.

4.2 Setting the clock

Press and hold the SET button for 2 seconds, "24Hr " will start flashing, then
-
press the + and - buttons to set.
Press the SET button to confirm the item setting and move to the next
-
one, the order of item setting is as follows:
24hr/12hr → hour → minutes → current weather → temperature unit (°C/°F).
5