Set Up Procedure With Rs232, Usb Or Ethernet; Interface Control - piezosystemjena FSM1x6 Bedienungsanleitung

10. set up procedure with RS232, USB, or Ethernet
RS232:
Please set the parameters for the RS232 as following:

115200 baud

software-handshake

no parity

8 databits

1 stop bit
Please use a normal serial cable (1:1, plug/socket) to connect your computer to
the RS232 on the fiber switch. Use the installation software to install the driver.
USB:
Parameters for the USB interface are not required, a USB cable is included. An
installation program to set up the USB driver is located on the CD or on our
website under www.piezosystem.com "products & services."
Ethernet:
With the help of USB - Ethernet converter SX-3000GB the corresponding
channels are selected via Ethernet interface.
For software installation and instructions, use the included CD.

10.1. interface control:

After powerup the RS232 sends a welcome string to the pc:
"piezosystem jena FSM12" followed by<LF><CR>
"piezosystem jena FSM13" followed by<LF><CR>
"piezosystem jena FSM14" followed by<LF><CR>
"piezosystem jena FSM16" followed by<LF><CR>
"piezosystem jena FSM19" followed by<LF><CR>
"piezosystem jena FSM112" followed by<LF><CR>
19
Geschäftsführer: Dr. Bernt Götz • Telefon 03641/66880 • Fax 03641/668866 • www.piezosystem.com