Control Commands; Bcd Code; Initiation; Pinning And Bcd Code Table - piezosystemjena FSM1x6 Bedienungsanleitung

10.2. control commands:

<CR> starts command recognition, erases input buffer
ch,1<CR> binary output 1
ch,2<CR> binary output 2
ch,3<CR> binary output 3
ch,4<CR> binary output 4
and so on

11. BCD code

11.1. initiation

The setup procedure is for F-162, 163, 164, 166, 169, 1612, F-142, 143, 144,
146, and 149.
The switching procedure will be realized by BCD code.
The parallel port (LPT1/LPT2) of your computer must be connected with 25 pin
D-SUB port of the switch.
If the red LED is illuminated, the switch is in operation mode.
The Software is provided on the CD or on the internet www.piezosystem.com.

11.2. pinning and BCD code table

The TTL-Interface is realized via the D-SUB25pin-socket. The cable is rated at a
2 m cable length.
D-SUB 25pin-socket
2
3
4
5
12, 13
24, 25
Geschäftsführer: Dr. Bernt Götz • Telefon 03641/66880 • Fax 03641/668866 • www.piezosystem.com
function
D0
D1
D2
D3
+5 V / 250 mA out
GND
table 5: pinning
20