Technical Parameter - Merax Ea35 Benutzerhandbuch

Autokühlschrank

Vorschau ausblenden

Inhalt

Seite von 17

/ 17
Inhalt
Inhaltsverzeichnis
Lesezeichen

Inhaltsverzeichnis

Verfügbare Sprachen

The code description

is shown in the table below:

Error code

Problem

The temperature

sensing head is

damaged

Input voltage is too low

DC fan over current protection

Abnormal

start of compressor

Abnormal

compressor speed

Module temperature

too high

Troubleshooting

If the product does not work properly.

1. Check whether the power is on.

2. Check whether the voltage is too low.

3. Check all connections

from battery to refrigerator

4. Check

the fuse.

5. Check whether the refrigerator

is turned on.

6. Check whether the temperature

set too high.

If the refrigeration

performance

is poor.

1. Too much food is put in the refrigerator.

2. The temperature

of the food in the refrigerator

3. The door is not closed properly.

4. Whether the door seal (sealing ring) is damaged.

5. Whether the ventilation

around the refrigerator

6. The environment temperature is too high.

7. Incorrect temperature

setting.

Solution

Please check or replace the temperature

sensor

Please check the input voltage and adjust

the battery protection

level

Please check the cooling fan

Please turn off the power and let it stand for

30 minutes

Please adjust compressor

operation

mode

(MAX/ECO)

Please move the refrigerator

to a ventilated

place to lower the module temperature

for looseness or poor contact.

is too high.

is good.

You can hear the sound of "water flowing"

This is normal. It is caused by the flow of refrigerant.

When the refrigerator

starts, the sound is loud.

1. Check whether the refrigerator

is placed on a flat horizontal

2. Check the surrounding

objects for vibration.

3. At the moment

of starting the compressor, when the motor runs from static to high speed, the

sound will be a little louder. After the speed is stable, the sound will decrease, which is a normal

phenomenon.

There are water drops around the shell or door seal.

It is normal for moisture

in humid air to liquefy and condense into water droplets when it comes

into contact with a lower temperature

shell.