Product Safety - Merax Ea35 Benutzerhandbuch

Product Safety

Do not touch the exposed power cord with your hands.
When using this product on board, please make sure that the power supply lines and fuses have
enough carried current.
If the AC device is used in the car, RV and yacht, it must be installed by professional
Make sure the power connection is correct.
Do not immerse this product in water.
Do not put cans, beer, etc. into the refrigerator
Do not place any electrical equipment in the refrigerator.
Only professional personnel are required for maintenance
Do not expose the product to the rain or strong sunlight for a long time.
After receiving and unpacking the refrigerator,
before using it.
Precautions for Use
(j) When using the refrigerator, please place it in a well-ventilated place, which is conducive to
heat dissipation. Especially, the gap between the cooling hole on the compression
objects must be greater than 100 mm, so as to prevent high temperature
affecting the refrigeration effect.
@ Do not keep the door open for a long time. The temperature difference between the inside and
outside of the refrigerator will cause the refrigerator
@ Do not clean the refrigerator under water.
@ Do not use the refrigerator near the heat source, it will reduce the refrigeration performance
of the refrigerator.
(S) Please use the refrigerator on a flat surface, do not use it on uneven ground for a long time, it
may affect the service life of the refrigerator
personnel.
for low temperature freezing.
service, or please contact your seller.
please leave it standing for more than 6 hours
side and other
from causing failure or
to form frost and affect the cooling effect.
and reduce the cooling efficiency.
TEMP UP
CHILD
TEMP DOWN
Introduction of Operating
Temperature control range: - 20 oc 20 oc
Temperature display range: - 30 oc 40 oc
Standard voltage input range: DC 12V / 24V, maximum not exceeding DC30V
1. Refrigerator opening and closing
Connect the correct DC 12/24 V power supply. If the refrigerator is in standby mode, the "- -" symbol
will be displayed in the middle of the display screen after the refrigerator
this time, long press the on / off button for 2 seconds to complete the start-up. After the start-up,
the display screen will normally display the current temperature
other characters. After the start-up delay (1 minute preset from the factory), the refrigerator
in the working mode, and the compressor starts to work for refrigeration.
press the on / off button for 3 seconds while the control panel is unlocked.
2. Refrigerator control panel locking and unlocking
If the control panel is locked (the child lock icon in the lower right corner of the display is on), press
and hold the "up / down" button for 3 seconds at the same time to release the lock. If there is no
operation for 20 seconds, it will automatically
3. Set the refrigerator temperature
When the control panel is unlocked, press the "up / down" key to adjust the temperature
fall of the refrigerator (a group of temperature values on the display screen flicker to display the
DISPLAY
ON/OFF
LOCK
SET
completes the self-test. At
in the container, working mode and
To turn off the refrigerator,
enter the control panel lock state.
works
rise or
[25