Cleaning And Maintenance - Merax Ea35 Benutzerhandbuch

current setting value. Each time you press the button, the temperature
you hold the button, you can quickly adjust to the desired temperature
within 5 seconds, the setting value will be saved automatically.
4. Set the compressor working mode
When the control panel is unlocked, press the "set" button to freely switch the compressor working
mode "Eco / Max". If you need to cool down to a lower temperature quickly, you can use the "MAXI'
mode. If you only need to use the refrigeration
energy and power.
5. Set the low voltage protection function
This product has the function of low voltage protection.
lower than the set value, it will automatically turn off the compressor to prevent over discharge from
damaging the battery or causing the car unable to start normally. At this time, the screen will display
"EI" code prompt. If the voltage returns to normal, the refrigerator
working state one minute later. The factory default is "Medium".
follow the following steps:
a: Unlock control panel.
b: Long press the "set" button for 3 seconds, release it after hearing the buzzer "Di", and then press
the "set" button one time. At this time, one of the battery
display will flash, and then press the "up / down" button to change the setting.
Refer to the table below for specific values:
Battery
12 v
Protection Turn off
Low grade - L
9.6 v
Medium - M
10.4 v
High grade-H 11.1 v
rises or falls by 1 degree. If
value. If there is no change
function, you can set it to the "ECO" mode to save
When it detects that the battery voltage is
will automatically enter the
If you need to change it, please
protection level icons "L, M, H" on the
12 v 24 V 24 V
Turn on Turn off Turn on
10.9 v 21.3 v 22.7 v
11.7 v 22.8 v 24.2 v
12.4 v 24.3 v 25.7 v
WARNING!
If your refrigerator enters the battery protection
supply voltage is insufficient and the low voltage protection
power supply wiring is improper and cannot provide enough current. Check whether the power
supply wiring is appropriate, and consider appropriately
In order not to affect the normal start of the car, it is recommended
at "H" when using the refrigerator on the car.
6. Single and double temperature zone function
This product has the function of automatically
middle partition, the default is double temperature
right zone is the refrigeration zone. At this time, the temperature
adjusted. Remove the middle partition as a single temperature
to the actual set value.

Cleaning and Maintenance

Before cleaning, it is necessary to disconnect
surfaces of the refrigerator with a cleaning cloth dipped with an appropriate
detergent. It is not allowed to wash with water directly
When the refrigerator is not used for a long time, it is necessary to clean the inside and outside of
the refrigerator and keep it dry, and take moisture-proof
and peculiar smell inside the refrigerator.
Error Code Description
When the compressor, module, fan and temperature
too low, the error code will appear on the display screen, and the compressor
After the abnormality is eliminated, unplug the power supply and plug it in again, the temperature
in the refrigerator can be displayed normally,
after 1 minute.
in advance, it may be because your power
value is set too high, or your DC
lowering the battery protection
to set the protection
identifying the temperature zone. Inserting
zone. The left zone is the freezing zone, and the
of the freezing zone can be
zone, and the temperature is subject
the power supply, and wipe the inner and outer
amount of water or
to avoid damaging electrical components.
and dust-proof measures to avoid mildew
sensor are abnormal and the input voltage is
will stop working.
and the compressor cooling mode will start to work
gear.
level
the