Lcd-Display - Hameg Instruments Hd 148 Bedienungsanleitung

Introduction
The HAMEG GRAPHIC PRINTER
print out hardcopy of the memory contents of nearly all
HAM EG digital and analog oscilloscopes for documentation
purposes. Each printout takes only about 17 seconds in Y/
t mode. Data transfer is not possible with type HM205(-
1) oscilloscopes, however. In order to obtain printouts of
waveforms, the oscilloscope
mode. Each printout provides
documentation of scope screen contents, supplemen-
ted with time of day, date and information
scope settings.
All parameters (e.g. time of day, date, zoom, etc.) are
entered using a user-friendly, menu-driven routine that
virtually excludes any possibility of mistakes, which also
trigger an audible warning (3 beeps).
Moreover, this unit permits both manual and automatic
capture of measurement
(using the built-in realtime clock), in response to a given
controlled (based on measurement
Controls and Indicators
4
O POWER SWITCH
(Power input located on rear panel of unit)
@ LCD DISPLAY
For displaying menus and additional information.
CONTRAST
For setting the display contrast to suit the viewing
angle.
FEED
Press to advance paper.
PRINT
Press to print out oscilloscope
screen contents.
SETUP +
Press to increment the displayed
numerical value.
SETUP -
Press to decrement the displayed
numerical value.
Subject to change without notice
HD148 can be used
must be set to storage
effective, good-quality
on certain
data, either timer-controlled
or )eve)-
signals in the scope).
GRAPHIC PRiNTER
to
The incorporated LCD display (backlit; 2 x 16 characters)
offers excellent contrast,
side or from a distance.
explanatory text.
The contents of the oscilloscope
to the HDI 48 via a HAMEG interface and a 26-way ribbon
cable with 2 connectors,
accessory.
If it is wished to use an HM 208 oscilloscope
Graphic Printer, it needs to be retrofitted
interface (H077). If the IEEE-488
already been installed in the scope, it must first be
removed to permit
possible to connect both the IEEE - 488 and the HAMEG
interface to the HM 208 at the same time. The H077 may
only be installed by HAMEG or one of its authorized
foreign representatives.
Type HM205-2 must also be equipped with the HAMEG
interface. Owners of this scope model can obtain it free
of charge from HAMEG under the designation H074. It
can be installed in just a few minutes by the user.
3 2 4 5
SETUP <
Press to move the cursor
@ SETUP
Press to move the cursor to the right.
MODE A
Press to advance to the next operating mode.
o MODE V
Press to return to the previous operating mode (the
corresponding menu
pressing the MODE UP and MODE DOWN keys
together).
MODE SELECT
For switching to another menu.
DRAWER
Holds printer assembly and the paper roll.
PAPER RELEASE
14
Normal position: down
For changing paper: up
Operating instructions
even when viewed
Each menu is shown
memory are transferred
which is included as a standard
with a HAMEG
interface H078
connection of the H077.
4
8 9
to the left.
header can be displayed
LEVER
ENGLISH
from the
with an
with the
has
It is not
3
by
•5