NOTICE
Reversely concluded all activated resistors from 100kΩ upwards are protected from
Reversely concluded
overloading up to the maximum decade voltage of 250 VAC rms / DC.
overloading up to the maximum decade voltage of 250 VAC rms / DC.
e) Conformity
e) Conformity
The appliance
The appliance
"cmt Mini-Decade
1:2010 (3rd Edition) + cor.: 2011 und IEC 61010-2-030:
1:2010 (3rd Edition) + Cor.: 2011 und IEC 61010-2-030: 2010 (1st Edition) at date of
print.
print.
NOTICE
If you have any further technical questions, please directly contact the
If you
have
manufacturer under:
manufacturer
under:
www.cosinus.de
www.cosinus.de
office@cosinus.de
office@cosinus.de
5. Maintenance
5. Maintenance
a)
a)
Fault Diagnostics
Fault Diagnostics
NOTICE
If any disturbance occurs, first check the fuse for its function. In case of a triggered
If any disturbance
fuse, ha ge it a ordi g to the pre ious haper
fuse, change it according to the previous chaper "change of fuse".
If the problem persists or the cause does not refer to the fuse, stop using the
-Y If the problem persists or the cause does not refer to the fuse, stop using the
decade und contact the manufacturer, e.g. under office@cosinus.de.
decade und contact the manufacturer,
b) Calibrating
b) Calibrating
Factory-provided every decade has been calibrated to ensure accuracy according to
Factory-provided
every decade has been calibrated
te h i al data i the appe di .
"technical
data" in the appendix.
NOTICE
Over the years the resistor values may show higher deviation.
Over the years the resistor values may show higher deviation.
If you wish a re-calibration, please contact the manufacturer.
If you wish a re-calibration,
c) Cleaning
c) Cleaning
After disconnecting ALL connection cables every person may clean the decade with a
After disconnecting
moist (not wet!) cleaning tissue under application of a mild (not aggressive!) cleanser.
moist (not wet!) cleaning tissue under application of a mild (not aggressive!) cleanser.
ATTENTION
Take care that no liquids get into the decade.
Take care that no liquids get into the decade.
all activated
t Mi i-Decade R1-3000 o for s to the urre t ersio of IEC 61010-
RI-3000"
any
further
technical
occurs, first check the fuse for its function.
please contact the manufacturer.
ALL connection
cables every person may clean the decade with a
[19]
[19]
resistors from 100kQ upwards
conforms to the current version of IEC 61010-
questions,
ha ge of fuse .
e.g. under office@cosinus.de.
to ensure accuracy according to
are protected
2010 (1st Edition) at date of
please
directly
contact
In case of a triggered
from
the