VEVOR YY-R108 Bedienungsanleitung Seite 9

1. Setting keypad ID (already set up before delivery )
● Plugging in the keypad and long press the [
displayed.
● Briefly press the [
keyboard ID).
● Entering a set of new numbers (1-999) and briefly press the [
to save the new ID.
● After setting up, briefly press the [X] button twice return back till the
screen display "0".
Note: Powering off the keypad and then plug it in again to check if the
keypad ID was set successfully.
2. Pairing the pager number(already set up before delivery)
Note:Before pairing, please charging the pager for more than half an hour
to ensure it has enough power.
● Putting all the pagers on the base and charge them.
● Long press the [
● Briefly press the [ →] button once until the "F2" is displayed.
● Briefly press the [
● Entering the desired number and quickly press the [
seconds after removing the pager from the charging base. The desired
number will be displayed on the screen of the pager after pairing
successfully.
● After setting, briefly press the [X] button twice to exit.
3. Setting the reminder duration for the pager: (The default duration is
20s.)
● Putting all the pagers on the base and charge them.
● Long press the [
● Briefly press the [ →] button twice until the "F3" is displayed.
● Briefly press the [
SETTING INSTRUCTIONS
] button, and there will be a set of numbers (i.e. the
] button until the "F1" is displayed.
] button again to enter the pairing mode.
] button until the "F1" is displayed.
] button again to enter the reminder duration setting.
- 7 -
] button until the "F1" is
] button within 3
] button