Radioddity CB-27 PRO Benutzerhandbuch Seite 6

2.11 VOX Setting
1. Turn on the power while pressing
setting
2. Short press
LX: stands for sensitivity level. allows the adjustment of the microphone for
an optimum transmission quality. Adjustable level form I (high sensibility)
to 9 (low sensibility)
tX: stands for delay time. allows avoiding the sudden cut of the transmission
by adding a delay at the end of speaking. The level is adjustable form 1
(short time delay) to 9 (long time delay)
3. Short press microphone
4. Hold
2.12 Scan function
1 Hold A/F to start scan function, "SC" falshes
2. Press microphone [ UP ] or [ DN ] to change scan direction during scan;
3 . Hold@or s hort press [ PTT] switch toexit s can f unction
2.13 Norms control
1 Hold@to power onradio, until LCD displays thenorms;
2. Press microphone [ UP ] or [ DN ] to choose wanted norms;
3. Power off and power on again
2.14 Install external
Choose a 16Q external speaker with 3.5mm mono connector.
A » WARNING: The sound output mode of the machine is BTL output, and
the two pins of the speaker cannot be connected to the ground net or the
machine shell! Otherwise,
the speaker,
2.15 Resume factory default
1 Hold so key to power on radio, until the LCD displays "rt", the resume
work finish.
2. All channel and function setting will resume factory default after above
operation
Visit Radioddity.com
flashes in the LCD
key to choose wanted setting
[ UP ] or [ DN ] to set desired level
key to store and exit setting.
speaker
there will be a large DC current flowing through
which will burn the speaker and components.
For Downloads And Help
key to enter the VOX function
in the LCD;