Sartorius Sartocheck 4 plus Betriebsanleitung Seite 59

Fig. 7-75 | Service Menu: Software configuration
Fig. 7-76 | Service Menu: Software configuration
Fig. 7-77 | Service Menu: Software configuration
The selections of the individual fields determine which fields are displayed and
accessible during an integrity test, as well as which fields will be printed out on the
®
Sartocheck 4 plus Filter tester's internal printer.
Note: Fig. 7-75 is valid for the protocol settings of the combined diffusion
and bubble point test.
Management Unit Parameters
In the submenu "Management Unit Parameters", you can set the following options:
F3: Edit parameters
Edits the management unit software parameters
F4: Save parameters to SD card
Saves the management software configuration file on SD card
F5: Save parameters to network
Saves the management software configuration file on the network in
the corresponding FTP directory
F6: Load parameters from SD card
Loads the management software configuration from SD card
F7: Load parameters from network
Loads the management software configuration from the corresponding
FTP directory in the network
F8: Print parameters
Prints the parameters of the management unit software
F9: Set standard parameters
Sets back the factory default parameters
Operation 59