VEVOR MS36127A3 Anweisungen Seite 7

ADDITIONAL SAFETY RULES FOR HOLLOW CHISEL MORTISERS
1. DO NOT OPERATE THIS MACHINE until it is assembled and installed
according to the instructions.
2. OBTAIN ADVICE FROM YOUR SUPERVISOR, instructor, or another
qualified person if you are not familiar with the operation of this machine.
3. FOLLOW ALL WIRING CODES and recommended electrical connections.
4. MAKE CERTAIN the machine is fastened to a supporting surface to prevent it
from tipping over during operation.
5. NEVER turn the mortiser "ON" before clearing the table of all objects (tools,
scrap pieces, etc.).
6. ALWAYS keep hands, fingers and hair away from the rotating bit.
7. DO NOT attempt to mortise material that does not have a flat surface, unless a
suitable support is used.
8. ALWAYS position holddown directly over workpiece to prevent workpiece from
lifting during operation.
9. ALWAYS support workpiece securely against fence to prevent rotation.
10. BE SURE drill bit is sharp, not damaged, and properly secured in the chuck
before operation.
11. MAKE SURE chuck key is removed before starting machine.
12. NEVER turn on the power with the drill bit or chisel contacting the workpiece.
13. NEVER perform layout, assembly, or set-up work on the table while the
mortiser is operating.
14. ADJUST the depth stop to avoid drilling into the table.
15. ALWAYS turn off the power before removing scrap pieces from the table.
16. SHUT-OFF the power, remove the drill bit and chisel, and clean the table
before leaving the machine.
17. FOR YOUR OWN SAFETY – Don ' t wear gloves when operating the
machine.
18. SHOULD any part of your tool be missing, damaged, or fail in any way, or any
electrical component fail to perform properly, shut off switch and remove plug
from power supply outlet. Replace missing, damaged, or failed parts before
- 6 -