Delphin FORZA Bedienungsanleitung Seite 2

EN: USER'S GUIDE
Set of electronic bite alarms with
RECEIVER/ functions:
SVOIl_jm e leves (switcherV,including silent mode)
5 different signaling tones( switcher)
Vibrationmode(togg e switch - right position)
q ca or signaling LEDs
Selected settings stared inmemory
ON/ OFF / VIBRAT O Ntoggleswitch
Memory diode - Ilt continuously for
Low battery indication with a short beep
Kit range test mode
Range up to 160mdepending on the terrain
Stand far convenient storage / HOLDrngFORZA
Power supp u lx9V batteru
BUTTON SCHEME
Antenna
Signaling
0000
LEDs
Rotary switch
/ tone
Speaker
MANUAL
Before starting: Openthe back cover of the receiver/ bite alarmto insert the batteries To do this, slide the cover down. Receiverand
the bite alarmare powered bu lx BVbatteru Before inserting the batteries, inspect them properluto make sure that theg are not leaking,
or otherwisedamagednsert the batteriesaccording to the correctpolarity(+and
duringlongerinactivitg inthe device,but remove them out
Pairing the receiver with the bite alarm: Wth the receiverswitched off and the bite alarmswitched on, holddown the P button an the
side of the receiver.Set the receiverswitch to the DAILY mode on / eft position Holddown the P button until the right and the left diode
illuminate Then se ect the desired diode location bu brief g pressing the P button
do a "bite" on the bite alarm To compete the pairing,turn the receiveroff and on
Receiver diode colour change: When the receiveris turned on,hold down the P button until the diode illuminates
Next, press the P button shortlu to choose the colour gou prefer To skip to the next diode. holddown the P button for a longertime
Range test: When testing the signal range,switch on the receiverfirst With the bite alarmoff, turn switch S to position no S Now switch
on the buzzer, the LEDsand beeps flashing continuously Youcan now move awag from the bite alarmwith the receiverto find out how far
it is receivingsignas Testing is finished bu turning off CAUTION:Rememberto leaveswitch S at evel S the range test starts again after
switching on and therefore there is a continuous beep again!
Warning: The vast majority of complaints about bite alarmsets are caused onlu bg batteries that no anger have sufficient capacitu
We ask you to test the condition of gourbatteries before a possiblecomp aint Thiswillprevent an unjustified complaint Thank uau
WARRANTY CARD
Model: Set Delphin FORZA
0 2+ 1
Date of purchase:
Stamp and signature of the seller:
a receiver
sec after the shot
Taggle switch, MODES:
I SOUND 3 VIBRATING
Button P
pairing / colour
Rotaru switch
V / volume
FORZA
/ *keep this card careful Ufor anu necessaru caims /
After sale warranty service:
After warranty service:
BITE ALARM / functions:
Waterproof
5 volumelevels(switch V,incudingsilent mode)
5 different signaling tones (Tswitcher)
5 sensitivitg evels(switch S)
7 possible colorsof the signaling diode(switcherC)
Toggleswitch DAY MODE /
Stares the selected settings in memorg
Possibility of attaching snag gear
Back bite signal - different tone
Memorg diade flashes for 20 sec after the shot
Low batteru indication with a short beep
Position night d10des
nput far 5 mm connector
Transport cover
Power supplu lx9V battery
Memoru diode
Rotary switch
T / tone
Rotary switch
C / diode color
Speaker
FORZA
nput 2 5mm
connector
Replace the coverandsecure it Donot store batteries
f gou have selected the position of the diode and its color,
TECHNICAL PARAMETERS:
Frequency band: 433 92 MHz
RFpower: 5.03 dBm
/ NIGHT M ODE
Snag
Bite diode
Rotarg switch
v
V / volume
Rotary switch
s
S / sensitivity
Toggle switch, MODES
I DAY