Warnings and Precautions
This appliance must be installed, commissioned and serviced by a qualified person in
accordance with national and local regulations in force in the country of installation.
Install or locate this appliance only in accordance with the provided installation
instructions.
Use this appliance only for its intended use as described in the manual. Do not use
corrosive chemicals or vapours in this appliance. This type of oven is specifically
designed to heat, cook, or dry food. It is not designed for industrial or laboratory use.
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified person.
Ensure that the mains supply plug and wall socket is accessible at all times.
Strip any plastic coating and clean the appliance before use with a soft cloth.
During operation parts may become hot - avoid accidental contact.
Disconnect this appliance before servicing conducting any maintenance or cleaning.
Precautions to avoid possible exposure to excessive microwave energy
If the door or door seals are damaged, the oven must not be operated until it has
been repaired by a competent person.
It is hazardous for anyone other than a competent person to carry out any service or
repair operation that involves the removal of any cover which gives protection against
exposure to microwave energy.
Avoid possible exposure to microwave energy - never try to operate with the door
open. It is important that the door seals properly when operating, therefore if the
door seals or hinges are damaged, do not use the appliance until it has been
repaired by a competent person. The door seal must always be kept clean and
debris free so that they perform the function of sealing the cavity when the
microwave is operating.
As a combined microwave and convection oven be careful using any plastic utensils.
Liquids or other foods must not be heated in sealed containers or closed glass jars
since they are liable to explode.
Microwave heating of beverages can result in delayed eruptive boiling, therefore care
must be taken when handling the container.
IS 903 ECN 5479
Page 4 of 208