PowerBox Systems Champion RRS Bedienungsanleitung Seite 8

f) Servo-matching
The servo-matching
extremely user-friendly. The Adjustor Board is the same one used on
the preceding model - the PowerBox
manufactured since
This is the sequence of events:
Important: at the start of the set-up process the backer must be 'taught'
the stick end-points and centre positions of your radio control system
transmitter for all three
obtain maximum precision in the settings.
This is the procedure:
- Disconnect the control surface linkages from the servos to avoid high
forces acting upon the as yet unmatched servos.
- Connect the adaptor board to the backer.
- Use the channel select switch to set the desired channel (A, B, C).
- Move the servo select switch to the "RESET"
- Press the + button and the
red LEDs now light up for this channel
- Leave the transmitter stick for the channel to be adjusted at centre;
trim also at centre. Now press the + button.
- Move the stick to one end-point and hold it there; press the + button.
- Move the stick to the opposite end-point and hold it there; press the
+ button.
The yellow LED now goes out.
procedure is very simple, and designed to be
2003.
match channels.
button simultaneously. The yel ow and
-08-
Champion - which has been
This is essential
position.
in order to