Herunterladen Diese Seite drucken

PowerBox Systems Champion RRS Bedienungsanleitung Seite 6

Vorschau ausblenden Andere Handbücher für Champion RRS:
Verfügbare Sprachen

Verfügbare Sprachen

d) Reading out the minimum
The minimum value memory shows you the lowest point to which the
voltage of each individual
minimum value is recorded, the culprit could be stiff control surfaces,
binding pushrods, or simply batteries collapsing under load, i.e. they are
not suitable for the model and type of servo. We strongly advise you to
make it a matter of routine to read out this minimum value memory after
every flight.
This is the procedure for calling up the function:
After the flight, press both switch buttons Battery I and Battery II and
hold them pressed in. The LED which now lights up on the PowerBox
Champion
RRS indicates the lowest voltage point during the last flight.
It shows substantial
more, i.e. not those which were of very brief duration.
e) RRS function
- Connect the receivers to the PowerBox
channels you select for the appropriate functions in your model is
up to you. The only proviso is that the transmitter's Fail-Safe function
must be programmed to a channel if you are using PCM or 2.4 GHz
receivers.
- Important:
all channels of both receivers which are connected to the
RRS
module
must also
This means:
channel
receiver
- A short distance away from the seven channel inputs for both
receivers you will find the sockets "FSI" and "FS2". Each of these
sockets is occupied by a channel of the receiver which was
programmed for Fail-Safe at the transmitter, e.g. channel 8. When
selecting receivers please ensure that they can be programmed to
respond to a Fail-Safe event, as most of the smaller receivers - such
as many six-channel or seven-channel units
facility.
- This free Fail-Safe channel must be programmed in such a way that
it switches from 0% to 100% (or from 100% to 0%) when a fail-safe
event occurs; it is important to read the transmitter manufacturer's
programming notes in this respect
value memory
battery fell during the last flight. If a low
voltage collapses
and settings
be connected
1 of receiver
"RX 1" must also be channel
-06-
which lasted one second or
Champion
RRS. Which
in the correct
numerical
do not include this
order
1 of
loading