Setting The Time - Xd Collection Xd P308.23 Bedienungsanleitung

CLOCK SETUP:
Connect the included cable to the alarm clock and then connect it to a wall
adapter.
The clock display will turn on when the clock is connectedto power.
1.Default time display 12-Hour,pressand hold the DOWNI button to toggle
between the 12•hour and the 24-hour clock.
2. Intime mode, short press ( LIP button to switch display mode, dP•1,dP-2,
3. Intime mode, press LIP button 2 seconds enter power saving setting
mode, displaf'•-Sd" meanspower saving mode in off status ;short press (
DOWN Jbutton meanspower saving mode om Inpower saving
mode, the LEDdisplay will turn off after 10seconds,pressany button or tap on
top of the alarm clock to turn on the LEDdisplay. Short press DOWN] button
again to turn off the powersaving mode, press SETJ or [ LIP] will return to
its default display mode.
4. Intime mode, short press [DOWN] button to adjust LEDdisplay brightness,
low brightness,medium brightness,high brightness.
SETTING THETIME:
I Pressthe [ SET]button until the time is displayed.
2. Press*hold the [ SET]button to set the time. The time hours will begin
flashing. Pressthe [ up ] and DOWN] buttons to adjust The dot in the upper
left corner ofthe display will appear when the hour is in PM_
5. Press[ SET save the hour setting. The minute digits will begin flashing.
Pressthe [ UP] and [ DOWN] buttons to adjust,amdpress [ SET] to saveJhe
clock will return to its default display mode.
ALARMTIMEFUNCTION:
1.Intime mode, short press [SET ]button enter alarm mode, display "e "
means alarm in ott status.
2. press[ UP] or [ DOWN]to turn on the alarm function, 12-Hoursdefaultthe
dot in the lower lett comer will display when the alarmis turned on.